Issue

The following message appears when installing a new module or addon to an existing Sage Pro installation:

WARNING!
Install has detected that you had the following module(s)
AP, AR, GL, IC, PO, SO
and you are trying to upgrade without selecting those modules.
It is recommended that you abort the install and contact your
Sage software solution provider. Proceeding further might cause
system failures or might not allow you to use those modules.
If you choose to abort, you will need to restore your Sage Pro ERP
installation from your backup to be able to use Sage Pro ERP.

Build Info
———–
Pro 7.5 Build 3500 with Service Pack 2

Steps to Recreate
—————–

1. Install Sage Pro 7.5 with core modules in the license key.
2. Create a new company with some of the core modules.
3. Install Sage Pro 7.5 over the top with the core modules plus some add-ons in the license key. At the point where you can select custom or typical setup.
4. Select Custom, then unselect the core modules you installed previously
5. Select System Files
6. Select an add-on and continue with the install and the warning message will appear.

© Copyright Sage Software